AdSense

Wednesday, March 5, 2014

Making Cabinet Doors Using a Kreg Jig

Cabinet doors! I made these with 1/2" birch plywood for the middle and 1x3s for the frame. I've made cabinets before with 1x2s and they often crack when I screw them together since they're a little too thin.

Once I drilled all the pocket holes with my Kreg Jig, I laid them all out back side up to screw together.


Since the middle piece is 1/4" thinner than the frame pieces, I put a piece of 1/4" plywood under it so the back is all flush while drilling in place.

Ta-da! I'm turning these into tilt out cabinets to hold trash and recycling cans, so I also added some 1x12s to the back.

Linking to:
http://www.remodelaholic.com/2015/03/welcome-door-week-diy-party/
 

1 comment:

  1. Pretty cool post.It 's really very nice and Useful post.Thanks website

    ReplyDelete